RF Accessories
Showing all 17 results
-
RF Accessories
CC2500 2.4Ghz
- Low power consumption.
- Operating Range: 30 meters
- Integrated bit synchronizer.
- Integrated IF and data filters.
- High sensitivity (type -104dBm)
- Programmable output power -20dBm~1dBm
- Operation temperature range : -40~+85 deg C
- Operation voltage: 1.8~3.6 Volts.
- Available frequency at : 2.4~2.483 GHz
SKU: NF-NF_FLG-3 -
RF Accessories
Lora Module 1278
- LoRaTM Modem 168dB maximum link budget
- +20dBm – 100mW constant RF output vs. V supply
- +14dBm high efficiency PA
- Programmable bit rate up to 300kbps
- High sensitivity: down to -148dBm
- Bullet-proof front end: IIP3 = -11dBm
- Excellent blocking immunity
- Low RX current of 9.9mA, 200nA register retention
- Fully integrated synthesizer with a resolution of 61Hz
- FSK, GFSK, MSK, GMSK, LoRa and OOK modulation
- Built-in bit synchronizer for clock recovery
- Preamble detection
- 127dB Dynamic Range RSSI
- Automatic RF Sense and CAD with ultra-fast AFC
- Packet engine up to 256 bytes with CRC
- Built-in temperature sensor and low battery indicator
SKU: NF-NF_FLG-1 -
RF Accessories
LORA SX1276
- LoRa Modem
- 168dB maximum link budget
- +20dBm – 100 mW constant RF output vs. V supply
- +14dBm high efficiency PA
- Programmable bit rate up to 300kbps
- High sensitivity: down to -148dBm
- Bullet-proof front end: IIP3 = -11dBm
- Excellent blocking immunity
- Low RX current of 9.9mA, 200nA register retention
- Fully integrated synthesizer with a resolution of 61Hz
- FSK, GFSK, MSK, GMSK, LoRa and OOK modulation
- Built-in bit synchronizer for clock recovery
- Preamble detection
- 127dB Dynamic Range RSSI
- Automatic RF Sense and CAD with ultra-fast AFC
- Packet engine up to 256 bytes with CRC
- Built-in temperature sensor and low battery indicator
SKU: NF-NF_FLG-5 -
-
-
RF Accessories
RFID Reader Module
This product has been used in building intercom and access control products for many years, it has high stability and strongest anti-interference ability. The ATMEGA8 of this module is a high- performance AVR MCU of AVR family. It’s easy to use and small enough to be embedded into your system. It will perform well in your projects.
SKU: NF-NF_FLG-1-4 -
RF Accessories
Semtech SX1262
- LoRa and FSK Modem
- 170 dB maximum link budget (SX1262 / 68)
- +22 dBm or +15 dBm high efficiency PA
- Low RX current of 4.6 mA
- Integrated DC-DC converter and LDO
- Programmable bit rate up to 62.5 kbps LoRa and 300 kbps FSK
- High sensitivity: down to -148 dBm
- 88 dB blocking immunity at 1 MHz offset
- Co-channel rejection of 19 dB in LoRa mode
- FSK, GFSK, MSK, GMSK and LoRa modulation
- Built-in bit synchronizer for clock recovery
- Automatic Channel Activity Detection (CAD) with ultra-fast AFC
SKU: NF-NF_FLG-1-2 -
RF Accessories
SX1278 LoRa Module 433M 10KM
This LoRa 433MHz module designed by AI-THINKER, which based on the chip SX1278. The SX1278 RF module is mainly used for long-range spread spectrum communication. It can resist Minimize current consumption. Thanks to SEMTECH’s patented LoRa™ modulation technology, the SX1278 has a high sensitivity of -148 dBm with a power output of +20 dBm, a long transmission distance and high reliability. At the same time, compared with the traditional modulation technology, LoRa™ Modulation technology in anti-blocking and selection also has obvious advantages, to solve the traditional design can not take into account the distance, interference and power consumption.
SKU: NF-NF_FLG-1-3 -
RF Accessories
USR-WIFI232-T
Introduction of Wireless WiFi Modules
The Wireless WiFi Modules, used for data transparent transmission. USR-WIFI232-T wifi module can connect with serial device for data transmission. It can send data from UART to WIFI in TCP client, TCP server and UDP mode.
Serial AT commands Settings
User can set parameter by module itself without going through another computer to configure. This setting method is used in the following situation: user have to configure IP address and destination IP address on site. AT command can meet the demand. After MCU connects serial server module by TTL (UART), MCU can configure setting by AT command.
SKU: 5487FB8/42 -
RF Accessories
USR-TCP232-T2
Serial to Ethernet Converter Modules | Ethernet UART Modules
Serial to ethernet converter modules USR-TCP232-T2 can transmit data transparently between TCP/IP and TTL, and it can also be applied in RS232/ RS485 by level shift circuit.
● Based on Cortex-M0 core.
● Pin type.
● Low Power, fast-speed and high-efficiency.
● Supports TCP server/client, UDP server/client
● Web page configuration / DHCP & DNS
● Virtual COMSKU: 5487FB8/41 -
RF Accessories
BNC_M Right Angle Cable Crimp Connector for RG223
This is a BNC plug connector for cable application. The RG142B, RG223, and RG400 etc. are the suitable cables for this connector. We suggest that the center contact has to be assemblied with the cable inner conductor by soldering, and the ferrule needs to be clamped on the cable for transmission and fixing.
SKU: 5487FB8/39 -
RF Accessories
BNCM_RG223 Straight Cable Crimp Connector for RG223
BNC Male to BNC Male Cable Using RG223 Coax
PE3087 is a BNC male to BNC male cable using RG223 coax. This Pasternack BNC male to BNC male cable assembly uses a 50 Ohm BNC for connector 1 and a 50 Ohm BNC for connector 2.
Our male BNC to male BNC cable assembly uses a flexible cable type that is 50 Ohm. Pasternack PE3087 BNC male to BNC male cable assembly is constructed with RG223 coax and the maximum VSWR is 1.4:1.
SKU: 5487FB8/11 -
RF Accessories
N_M to SMA_F Straight Converter ( A )
Digi-Key Part NumberADP-SMAF-NM-NDManufacturerRF SolutionsManufacturer Product NumberADP-SMAF-NMDescriptionCONN ADAPT SMA JACK TO N PLUGDetailed DescriptionAdapter Coaxial Connector SMA Jack, Female Socket To N Plug, Male Pin 50OhmSKU: 5487FB8/08