Recommended Products
Joy Stick Arduino Joystick PS2 Breakout
Phillips is a two-way rocker 10K resistor, with the joystick in a different direction, tap the resistance vary. This module uses a 5V supply, the original state X, Y readout voltage of 2.5V or so, when pressed with the direction of the arrow, the readout voltage values with increasing, up to 5V; press the arrow in the opposite direction, the readout voltage reduction , a minimum of 0V.
HC-SR501 Pyroelectric Infrared Sensor Module
The PIR Motion Sensor Detector Module HC-SR501 allows you to sense motion. It is almost always used to detect the motion of a human body within the sensor’s range. It is often referred to using “PIR”, “Pyroelectric”, “Passive Infrared” and “IR Motion” sensor.
Arduino UNO R3 With Atmega328P Microcontroller
Microcontroller : ATmega328
Operating Voltage :5V
Input Voltage (recommended) :7-12V
Input Voltage (limit ) :6-20V
Digital I/O Pins :14 (of which 6 provide PWM output)
Analog Input Pins :6 DC
Current per I/O Pin :40 mA
DC Current for 3.3V Pin : 50 mA
Flash Memory :32 KB (ATmega328) of which 0.5 KB used by bootloader
SRAM :2 KB (ATmega328)
Clock Speed :16 MHz
Arduino Mega 2560 with Cable
The Arduino Mega 2560 is a microcontroller board based on the ATmega2560. It has 54 digital input/output pins (of which 14 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button.
IR Infrared Flame Detection Sensor Module
IR Flame Sensor Module infrared Receiver Ignition source detection module This tiny Flame sensor infrared receiver module ignition source detection module is Arduino compatible can use to detect flame or wavelength of the light source within 760nm~1100nm also useful for Lighter flame detect at the distance 80cm. Greater the flame, farther the test distance.
It has the Detect angle of 60 degrees and very sensitive to flame spectrum. It produces the one channel output signal at D0 terminal for further processing like an alarm system or any switching system. The sensitivity is adjustable with the help of blue potentiometer given on the board.
Arduino BMP180 Barometric Pressure Sensor Board
N_M to SMA_F Straight Converter ( A )
Digi-Key Part Number
|
ADP-SMAF-NM-ND
|
|
Manufacturer
|
RF Solutions
|
|
Manufacturer Product Number
|
ADP-SMAF-NM
|
|
Description
|
CONN ADAPT SMA JACK TO N PLUG
|
|
Detailed Description
|
Adapter Coaxial Connector SMA Jack, Female Socket To N Plug, Male Pin 50Ohm
|
2SC2782 VHF BAND POWER AMPLIFIER
Specifications:
Adafruit HUZZAH32-ESP32
A feature-rich MCU with integrated Wi-Fi and
Bluetooth connectivity for a wide-range
of applications
Shop
Showing 1–24 of 153 results
-
RF Accessories
CC2500 2.4Ghz
- Low power consumption.
- Operating Range: 30 meters
- Integrated bit synchronizer.
- Integrated IF and data filters.
- High sensitivity (type -104dBm)
- Programmable output power -20dBm~1dBm
- Operation temperature range : -40~+85 deg C
- Operation voltage: 1.8~3.6 Volts.
- Available frequency at : 2.4~2.483 GHz
SKU: NF-NF_FLG-3 -